I recovered the post because it was done in the vortex of the competition ...
time ago I found this nice point in two anglophone blog and there have been many requests for a translation into Italian. While I was filming and I'm done I created a small video where you can easily see how to do this. From what I saw is something that is better if you work slow and the end result is a bit 'close to work than the usual number of links to law. Can help a lot also use the rods with size slightly larger than those recommended by the yarn. You just have to do many tests and see what the highest satisfaction!
The mesh is normally mounted from the first lap and then you start working the plug point.
Law: Take 2 meshes with the reverse side of the work, usually with straight stitch the stitches are taken from the front side instead of from behind. This work links the two as if you were a decrease in the mesh and then when you slide them off the left needle is left on an iron. Then you take another 2 shirts, one that had already been processed and a new, processed mesh the two together and again the second link is on the left needle. And so for all the iron. Arriving at the end, working the last two links and leave the iron on the last, working individually taking it inside out like the others. If you do not you are working around the meshes decrease around.
Reversal: It brings the right needle over the wire, take two mesh together like a normal back and work. As was done for the right one link is left on the left needle and the other is the parade. They take other 2 meshes, one is the one that has already been processed and the other is new ... and so for all the iron, making sure to work well the last link as explained above
I tried to use more colors to see what was the effect
0 comments:
Post a Comment